Boiler Tube Expander
Tube Removal Tools
Tube Rolling Equipment
Boiler Tools Accessories
Vacuum Tube Leak Detector Kit
Tube to Tube Leak Detector
Tube/Pipe Beveling Equipment
Sugar Mill Tooling
Tube Expanders for Exchangers
Tube Installation Tools
Rolling Controls and Drives
Removal Tools
Spring Tool Balancers
Continuous Tube Pulling System
Flange Spreader
Tube Cleaning Brushes
Tube Expansion System
Hetran Bar Guide Pads & Acc.
Tube Cleaners
Contact Wheels
Bolting Tools
Impact Sockets / Power Sockets
Hydraulic Bolt Tensioners
Tube Installation Tools
ST Series Grooving Tools, also known as Serrating Tools, can be used manually to clean up existing grooves or can be used in milling or drilling equipment for OEM tube sheet thicknesses of 7/8” (22.2mm) through 2-1/8” (54.0mm). The ST Series Grooving Tools feature a one-piece mandrel design to significantly improve performance and accuracy. Using standard ST Series cutter bits allow for repeatable, accurate cuts from tube sheet hole to tube sheet hole.
The NW Series allows changing of the pilot nose and cutter allows one tool to cover a range of sizes.
Serrating/Grooving Tool ST Series
Serrating/Grooving Tool NW Series
Tube End Facer TEF Series
Tube End Facer FB Series
Tube End Facer FC Series
Tube End Facers are the ideal tool for quick facing of projecting tube ends in heat exchangers, condensers and boilers. One size of tool is suitable on multiple tube thicknesses by interchanging the pilot bearings which come with each tool. By quickly adjusting the depth gauge many tubes can soon be faced to the exact projection required. Tool bits are for either Ferrous or non-ferrous applications and spare tool bits are always available. With the FB Series the tool bit can be reversed therefore it doubles its life.
Tube Sheet Reamers Morse Taper
Tube Sheet Reamers Chucking
Flaring Tool
Tube Sheet Hole Brushes
Tube Guides
Vacuum Tube Leak Detector
Tube to Tube Sheet Leak Detector